If one of the three feet came off, we’re talking about the feet of the kirah (stove). So now the kirah is tilted to one side. Two other feet become tamei (ritually impure) through direct contact, but they do not become tamei through their airspace. If they become tamei from a sheretz (creeping creature) that touches them, because the kirah is still usable even though one of the feet is missing, but they do not become tamei from a sheretz that enters the airspace because a kirah can be used this way only with difficulty. So the tumah (ritual impurity) is only derabbanan (rabbinic type of tumah) over here because it’s not such a functional kirah anymore. Whenever we have a derabbanan type of tumah, we don’t want to make it fully tamei across the board, because then people are going to think that it’s a biblical type of tumah. So we’ll allow it in one instance because we don’t want people to think it’s biblical and then burn Terumah (priestly offering) or kodesh (sacred offering) that’s really in contact with it, when you’re not allowed to because it’s only rabbinic type of tumah. For a biblical type of tumah, you would burn the Terumah. So we want to show clearly that it’s rabbinic, and therefore we’re not going to make a decree across the board. This is divrei Rabbi Meir. This is the opinion of Rabbi Meir. Rabbi Shimon metaher (declares ritually pure). But Rabbi Shimon says no. According to Rabbi Shimon, the two remaining feet are fully tahor (ritually pure). Hachamim (Sages) did not make partial tumah for earthenware utensils. Therefore, if they didn’t want to make a decree for the airspace, they wouldn’t make a decree for contact either.
We have a different machloket (dispute) about another example of a two-footed kirah. If you made the kirah with two feet to begin with, one on one side and one on the other, the kirah was stable. The feet over here would be wider in order to allow the kirah to stand without tipping over. They become tamei through contact and through airspace. This is the opinion of Rabbi Meir. Even though a kirah that stands on its feet usually has three feet, here it was made with two feet, and the feet become tamei even through airspace. But Rabbi Shimon says no: the two feet are tahor.
Now we’ll go back to a kirah that has three feet. We learned in the last Mishnah that if the feet were three fingers high or less, they become tamei. Here we’ll learn the law in a case where they were more than three fingers high. If the feet under the kirah were more than three fingers high, the parts of them from three fingers and under—the parts within the first three fingers from the bottom of the kirah—become tamei through direct contact and through airspace because they’re considered part of the kirah. But the parts from three fingers and above, more than three fingers away from the kirah, become tamei only through direct contact and do not become tamei through their airspace. That’s the opinion of Rabbi Meir. Rabbi Shimon again says no: the parts of the feet that are more than three fingers away from the kirah are completely tahor. They do not become tamei even through direct contact. Consistency with Rabbi Shimon throughout the machloket: that’s how he holds, that there’s no halfway tumah. So the extra length does not become tamei at all.
Certain types of kirot had feet that weren’t under or below the kirah, but were attached on the side through horizontal bars that extended out from the bottom of the kirah. Here we’ll talk about how close to the kirah the feet have to be to become tamei through airspace. If the feet were not directly under the kirah but were pulled away from its edge, so there was space between the legs and the sides of the kirah, the parts of the feet within three fingers of the edge become tamei through direct contact and through airspace. But anything beyond three fingers from the edge becomes tamei only through direct contact, not through airspace. This is the opinion of Rabbi Meir. Rabbi Shimon says that the parts of the feet more than three fingers away from the edge are completely tahor.

